Replenishment: Buyers Push

(0) Share

Report

Posted on by Community Member

hello all

i have a question regarding buyer's push. i have defined weights in the replenishment rule but the qunatity is not getting distributed according to the replenishment rule. For eg if i mention 10 in the quantity to distribute box and calculate only 7 gets distributed and it doesnot even gets distributed according to the replenishment rule i have defined. Infact it even leaves one store with no quantity being distributed.

Kindly help me on this asap.

*This post is locked for comments

I have the same question (0)

All responses (4)

Answers (0)

Zain Mehmood 4,187 Most Valuable Professional on at

Like (0)

Report

Hello,

Were you able to resolve this issue? Because currently I'm facing the same in Buyers Push.

Was this reply helpful? Yes No
g.casillo 185 on at

Like (0)

Report

Hello,

I have setup the replenishment rules and service category but i not able to associate the replenishment rules when i create the buyer's push :(

how can i perform it?

Was this reply helpful? Yes No
Suggested answer

sumit0417 2,890 on at

Like (0)

Report

Hi Casillo,

When you create buyers push, for any item, the warehouse gets populated automatically on the basis of the replenishment plan associated with the product. When you select Repelishment rules under Warehouse fast tab, it picks the Warehouse from product and you will not be able to select any specific Replenishment rule. However if you want to select then you can do it by selection location weight.

Was this reply helpful? Yes No
g.casillo 185 on at

Like (0)

Report

Hi Sumit,

Thank you so much.

Best regards,

Gianni

Was this reply helpful? Yes No