Glitch while switching one company to another company

(0) Share

Report

Posted on by Community Member Microsoft Employee

Hi,

Please help me with the below issue:

In Ax 2009 from the status bar while trying to switch company, I am getting an error as, "Not enough rights to use Company Data Table(DataArea)". Please note that, it is happening with only few users, not with the all. Also I have checked the Configuration utility in Admin module as well as domain configuration too.

Appreciate your help.

*This post is locked for comments

All responses (3)

Answers (0)

Suggested answer

Community Member Microsoft Employee on at

Like (0)

Report

RE: Glitch while switching one company to another company

Switch them to admin and see if it works.

Also, the user profile might be corrupted. You can delete the profile and reimport the user back into the system.
Community Member Microsoft Employee on at

Like (0)

Report

RE: Glitch while switching one company to another company

Thanks for your reply. The funniest thing is that, if the User close the system and again reopen, then it is allowing the user to do so, that's clarify that, the user is having access to the form and table as you referred.
Suggested answer

Community Member Microsoft Employee on at

Like (0)

Report

RE: Glitch while switching one company to another company

Greetings Chinmoy,

I would check the user permissions for the users who are getting this error. If you don't have access to that table (DataArea) or possibly the form, you won't be allowed to switch companies. Perhaps temporarily switch them to ADMIN to see if it resolves the problem, if it does the users will need their permissions modified.

Best.