Earning Statement

(0) Share

Report

Posted on by Lakshminarayanan

I am trying to create earning statement with only basic salary component , I have created necessary earning code with basic component checked and base definition to base time. When I am trying to create a earning statement after selecting the earning code and updating the quantity , the Rate and amount field will remain unchanged , I tried all possible ways but i am not sure where to set up rate and amount so that once the earning code is selected , it should also automatically get update.

Please advise,

Lakshmi

*This post is locked for comments

I have the same question (0)

All responses (1)

Answers (0)

Suggested answer

CU27040849-8 4 on at

Like (0)

Report
Copy link

Link copied!

When setting up an earnings statement with a focus on the basic salary component, it's crucial to ensure that your earning code is correctly configured to auto-update the rate and amount upon selection. If after selecting the earning code and adjusting the quantity, the rate and amount fields don't change, the issue might lie within the base setup of your system. Check if the rate and amount are defined to dynamically adjust based on the selected earning code. Sometimes, the solution lies in adjusting settings within the payroll software's configuration or revisiting the earning code's properties. For additional resources and guidance, consider exploring Dream99, which might offer alternative insights or solutions to enhance your setup. Ensuring the automatic update of rate and amount requires a detailed review of both your earning code configuration and system settings.

Was this reply helpful? Yes No