Microsoft Dynamics AX (Archived)

License plate number sequence

(0) Share

Report

Posted on by sri17

346

Hi All ,

AX 2012 R3

Could any one help that number sequence issue is abnormal .

License plate number sequence setup as non-continuous . The numbers were not used sequentially and jumps to different number .The issue is that number sequence skip numbers and skip number range is high .

For example - Assume that current LP number is 501 , when creating the LP , the next number should be 502 ,but system takes 707 . The LP number sequence is not used any other modules .

We are unsure that what might be cause of this issue ?

Thanks in advance.

*This post is locked for comments

I have the same question (0)

All responses (14)

Answers (0)

Suggested answer

Srini Ramidi 2 on at

Like (0)

Report

Hello,

Numbers from a non-continuous number sequence are used sequentially, but the number sequence may skip numbers. So obviously continuity is not guaranteed and its common.

technet.microsoft.com/.../hh209457.aspx

Best,

Srini

Was this reply helpful? Yes No
Weaveriski 23,620 Moderator on at

Like (0)

Report

Is it a shared number sequence or company specific?

Was this reply helpful? Yes No
sri17 346 on at

Like (0)

Report

Hi ,

The number sequence is Company specific .

Any help here to rid off the issue ?

Was this reply helpful? Yes No
sri17 346 on at

Like (0)

Report

Hi All ,

Any inputs to understand the issue ?

Was this reply helpful? Yes No
Weaveriski 23,620 Moderator on at

Like (0)

Report

I can only suggest debugging. Company specific and not continuous will just mean "next" is used and the increment is 1. You could try the manual clean up.

If this is the only Number sequence ensure you have no impacting customisations, because it is strange if that is the case, then you can also check LCS for any fixes in the areas depending upon your CU (Lots came in for WHS in CU8-10).

Was this reply helpful? Yes No
sri17 346 on at

Like (0)

Report

[quote user="Weaveriski"]

I can only suggest debugging. Company specific and not continuous will just mean "next" is used and the increment is 1. You could try the manual clean up.

[/quote]

Thanks Weaversiki for the reply .

The license plate number sequence issue is not reproducible in other environments and exists in prod environment only . I'm afraid how to take it further analysis .

Was this reply helpful? Yes No
Weaveriski 23,620 Moderator on at

Like (0)

Report

Create a brand new sequence. After that your only option is to get a developer to debug it.

Was this reply helpful? Yes No
Suggested answer

Ivan (Vanya) Kashperuk on at

Like (0)

Report

Non-continuous number sequences can use a perf-improvement feature, called Preloading, where the AOS takes out a set of numbers when a number is requested, and then goes and uses those without needing to go back to the DB.

Check if maybe that's your case.

Was this reply helpful? Yes No
sri17 346 on at

Like (0)

Report

Thanks Ivan ,

Could you guide me how to check the above setup what you have shared ?

Was this reply helpful? Yes No
Ivan (Vanya) Kashperuk on at

Like (0)

Report

That's just on the Number sequences form for that specific number sequence.

Was this reply helpful? Yes No