Finance | Project Operations, Human Resources, ...

PowerBI Tiles in D365 Finance and Operations - Open Tile Catalog

(0) Share

Report

Posted on by Community Member

Hi,

I am attempting to pick up and pin a tile from the PowerBI service into D365 Finance and Operations workspace. I have seen another post which is a similar but not exactly the same issue I am experiencing.

My issue.

I create a tile in PowerBI service
I go into a workspace in D365 F&O
I go to options and open the Tile Catalog and I see the image below.
- But the Tile content is available in PBI Service
- I am able to add Reports from the Open Report Catalog - so I know that the application ID/Key etc are all fine it is just the tiles that do not show any data here.
- I can click and add the tile but I cannot see any data?

Any ideas? Am I missing something basic here?

Thanks in advance

Declan

I have the same question (0)

All responses (4)

Answers (0)

Prakash Kavar 20 on at

Like (0)

Report

Hi Declan,

Can you please give us more details about the error screen ? Not able to view attached image .

Thanks,

Prakash

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

HI Prakash,

The screen says,

The content is not available

Learn more about PowerBI

Thanks

Declan

Was this reply helpful? Yes No
Suggested answer

Prakash Kavar 20 on at

Like (0)

Report

Hi Declan,

If this is the first time you access the reports, please perform an Entity Store refresh as below steps:

1. Go to System administration ->Setup -> Entity Store
2. Tick all the entity store > choose Refresh > choose OK:

3. Go to System administration > Inquiries > Batch job, search for “Full reset” or “Deploy measurement” in Job description:

4. Wait until Status of the batch job is Ended. Then try to access your Powerbi tiles again..

Was this reply helpful? Yes No
Community Member on at

Like (0)

Report

Hi Prakash,

Thanks for this update but yes I have updated and refreshed Entity Store and refreshed entities. I do this all the time as we currently deploy our PowerBI reports built in the VMs via the LCS. When we deploy I always update Entity.

Just so you know - when I open REPORT catalog (which looks at the 'My Workspace' in the PowerBI service) I can find and add my reports to a workspace.

However the Tiles do not seem to work.

As an additional question just in case you have had some experience with this - do you deploy and use PBI reports in your D365 Finops environments? If you do what method do you use to deploy - via PBI embedded controller in AOT OR LCS?

Regards

Declan

Was this reply helpful? Yes No