Report as Finish came out twice of the Started number.

(0) Share

Report

Posted on by Pixcy

In my scenario, While performing "Report as Finish" i used to tick on "Accept Error" to make system accept the changes made when "Picking list" is posted. Till here everything goes fine, but upon doing "End" of the Production Order, it creates 2 lines in the "Reported as Finished" journal. Now i have one line of Picking List, Route card, but on the "Report as Finished Journal" i have two line, declaring twice the number of "Report-as-Finished" (including Finished goods, and co-products) as i have Started for production. I should have Reset status, but i have already Ended the Batch-Order.

Please help me out.

*This post is locked for comments

All responses (3)

Answers (1)

Verified answer

Pixcy 35 on at

Like (0)

Report

RE: Report as Finish came out twice of the Started number.

I posted a negative BOM journal RAF to cancel out the excess RAF posted at the end of the batch order, and then mark the lines of the BOM journal to the Batch order before posting. Note: I also have to change the session date to the date the RAF of the Batch order was posted, before i started this process.
Pixcy 35 on at

Like (0)

Report

RE: Report as Finish came out twice of the Started number.

Thanks for your response Fredrik, tried that already, but i get a response,"Production status Ended does not allow posting the journal", cos i have already ENDED the Batch Order.
Fredrik Sætre 12,644 on at

Like (0)

Report

RE: Report as Finish came out twice of the Started number.

You can post negative RAF-journals to negate this.