Wrong LookupFormID,DrillDownFormID or LookupPageID,DrillDownPageID on TAB310

(0) Share

Report

Posted on by Yukon

714

I was found TAB310(No. Series Relationship) LookupFormID,DrillDownFormID or LookupPageID,DrillDownPageID is pointing to wrong Form or Page(No. Series Lines). I assume it should be FRM458 or PAG458(No. Series Relationships).

2009R2-SG, 2013 ~ 2016(AU). I'm not sure on W1.

Regards,

*This post is locked for comments

I have the same question (0)

All responses (3)

Answers (0)

Suggested answer

Alexander Ermakov 28,096 on at

Like (0)

Report

I'm not sure for W1 2009, but in 2016 in the 310 Table it looks correct by pointing to No. Series table for looking up the Description:

=Lookup("No. Series".Description WHERE (Code=FIELD(Code)))...

What build do you have? Are you sure it is not customized?

Was this reply helpful? Yes No
Yukon 714 on at

Like (0)

Report

Hi Alexander,

Thanks for your reply. Are you looking on Table Properties or Field Properties. I found it on Table Properties.

Table Properties

Field Properties (same as your version)

Regards,

Was this reply helpful? Yes No
Suggested answer

Alexander Ermakov 28,096 on at

Like (0)

Report

Oh, now I have got your point.

Yes, to me it looks like a bug, cased by the fact that most likely guys just copied one property from another :-). This is actually the same for W1 2016 version. If you would address this table this way, you'll get an error. However, I do not remember that this table is addressed anywhere throughout the whole database this way. You only open it from the menu to establish the relations between number of series, and that is it.

You can report this as a bug I suppose, but it does not spoil life much :-)

Was this reply helpful? Yes No