Release order dimensions

(0) Share

Report

Posted on by Community Member

Good day

I would like to enquire about the dimensions(header sections) on a Release Order, generated from a Blanket Order.

I created a Blanket Order through AP. Then I created a release order off this Blanket Order. The dimensions (as were filled in on the Blanket Order) do not all pull through on the header section of the ‘newly created PO’, but the dimensions on its line section do. Can anyone please give me advice on this? Can these header dimensions all pull through or do they need to be re-populated every time a Release Order gets created?

Thanks

Hannes

*This post is locked for comments

I have the same question (0)

All responses (1)

Answers (0)

Polo Li 355 on at

Like (0)

Report

One way is that you define the default deminsion on vendor, then AX will copy it to the released purchase order

Best regards,

Was this reply helpful? Yes No